EG-401 Microgrinder

EG-401 Microgrinder



The microscope is mounted on the EG-401 Microgrinder, which uses a special motor to minimize irregular movements of the grinding plane: confirmation of contact between the pipette and the grinding plane enables grinding to be performed with greater precision. In addition, the EG-401 Microgrinder provides stable performance at all revolution speeds – from low for more precision to high for faster grinding. An easily operable coarse and fine movement coaxial manipulator is equipped for vertical operation of the micropipette, which also enables very precise grinding. A protractor is mounted on the pipette holder fixing section, making it easy to set the required grinding angle, and an adaptor is attached for vertical grinding. New water filling and drainage mechanisms are installed to prevent clogging or the accumulation of shavings, making the apparatus as a whole much easier to use.

Accessories included Adaptor for Vertical Grinding
Diamond Wheel Cleaner
Dedicated Pipette Holder
Hex Wrench
Power Cord
Movement range Up-and-Down Manipulator: Approx. 47mm
Microscope: X approx. 7mm, Y30mm, Z approx. 8mm
Magnifications 30× (Eyepiece 10×, Objective Lens 3×)
Glass capillary ø1mm ~ ø1.5mm
Working voltage AC100V ~ AC240V, 50/60Hz
Power consumption 10W
Motor speed Approx. 150rpm ~ 2,000rpm
(The diamond wheel may be stopped under 150rpm.)
Dimensions/Weight W250 × D450 × H400mm, 6.6kg

Read more




Consent to being contacted via:
By submitting, you are subject to terms and conditions of our privacy policy.